Top » Catalog » Vinyl, Tuning Film » MACtac Iridescent » vin4tuneidpearl60
Vinyl, Tuning Film
  3M Di-Noc, 180C
  MACtac Brushed Metal BF
  MACtac Carbon BF
  MACtac Iridescent
  MACtac Matte
  MACtac Stellar BF
  MACtac Textured
  MACtac Velvet BF
  Sublime BF Gloss
  Sublime BF Matte
Tuning Film TF3015 Iridescent Pearl 3.9mil 60"
$27.17 /lft
82+ lft
$24.45 /lft
Regular Price:$27.17 /lft
82+ lft Price:$24.45 /lft
Available Options:
Qty (lft):  

Tuning Film Iridescent Pearl is a 100μm soft cast vinyl film coated with a low tack high performance acrylic adhesive. This product has a pearl colour appearance, with reddish and greenish light reflection effect. Tuning Film Iridescent Pearl is designed for vehicle striping and/or full car wrapping.

Face material :

100μm soft cast vinyl, glossy, cadmium-free.
Adhesive :
Repositionable black solvent based acrylic adhesive.
Liner :
Highly stable 130 gsm white PE coated paper.

Vertical exposure: 3-4 years in zone 1 (North & central Europe)
Horizontal exposure : reduced by 40%

These use-life estimates are based upon accelerated ageing studies and outdoor exposure, under conditions experienced in vertical exposure and in West Europe.

Note : Exposure to severe temperatures and ultraviolet light, as well as conditions in Southern European countries, and also in tropical, sub-tropical or desert regions, will cause a more rapid deterioration. This also applies to polluted areas, high altitude, horizontal and south-facing exposure.

Temperature ranges :
Application : +15C to + 40C
End-use : - 40C to + 90C

Flammability ISO 3795
Sample mounted on aluminium : self-extinguishing.

Solvent and chemical resistance
Resistant to most oils and grease, fuel, aliphatic solvents, weak acids, salts and alkalis.

Clean and degrease the substrate

All surfaces to which the material will be applied must be thoroughly cleaned from dust, grease or any contamination. Use soapy water to remove the dust and degrease the car surface with isopropylic alcohol.

on flat or slightly curved surfaces

Apply directly on the car by the dry application method.
on convex areas
Heat the film with a heat gun before stretching it over the convex area.
on corrugated or concave areas
If the film is stretched into a too deep corrugation it may pop-out after a few weeks. It is, therefore, recommended to cut the film and to apply it in the corrugation without tension.

Once heated, Tuning Film Iridescent Pearl can be removed with small adhesive residue on the car body.

Important remarks
The compatibility of paints and lacquers should be tested by the end-user, prior to use.

  WJT Sign Supply is not responsible for typographical or photographical errors.
  Prices are listed in Canadian funds and specifications are subject to change without notice.
  WJT Sign Supply
  160 Bentley St. Markham, Ontario, Canada L3R-3L2
  Toll-free: 1-800-465-8650
  Tel: 905-475-2632
Copyright © 2005 WJT Sign Supply.
Powered by osCommerce