RB599H is a 4-mil soft; clear gloss, polymeric stabilized PVC film designed for solvent-based ink jet printing and screen printing. The liner is a 90# SuperFlat™, C2S polycoated that provides excellent layflat. This durable flexible vinyl has good outdoor durability. The adhesive has a high initial tack and builds to a high strength, permanent bond with good resistance to creep, solvents and heat. Suggested uses include screen-printed labels, decals, markings, point-of-purchase displays and signs for indoor and outdoor use.

INTENDED FOR:
Screen printing or wide format inkjet printing including, eco-solvent, solvent-based, latex and UV-cured inkjet. To achieve the best possible print quality, please make sure that the correct ICC profiles or printer settings are used. Profiles can be obtained from our Distributors or can be downloaded from www.mactac.com. Printer and heater settings and ICC profiles can also be downloaded from some O.E.M. or software manufacturer’s websites. The ICC profiles are provided solely as a customer resource. Print environments, the individual nature of printing systems, inks and software can significantly affect output. It is the customer’s responsibility to determine the suitability of any profile for use in their specific print environment.

SHELF LIFE:
This product is good, unprinted, for two years when stored at 75°F (24°C) and 50% relative humidity or less.

DURABILITY:
Seven years indoors and up to 5 years outdoors in a vertical application .This use-life estimate is based upon accelerated age studies. Please note that exposure to severe temperatures, ultra-violet light and also in tropical, sub-tropical or desert regions will cause more rapid deterioration. This also applies to polluted areas, high altitude and south facing exposure.

RECOMMENDATIONS:
Always test your combination of REBEL products, inks and laminating films prior to commercial use.

1. Printing Conditions: Print in conditioned pressroom at ±73°F (23°C) and 50% RH. The maximum allowable ink saturation is 270%.
2. Drying Requirements: Solvent, Eco-solvent and Mild-solvent inkjet prints require 24 - 48 hr. drying time - open to the air. Inks do not dry when printed media is rolled up. The prints must be dry prior to lamination.
3. Laminating Conditions: If the printed graphic is likely to be exposed to corrosive liquids, smoke, fumes, and highly polluted areas or there is a likelihood of scratching, it is highly recommended to laminate with Permacolor IP7000 Series or LF3600 High performance overlaminating films.
4. Transportation Conditions: To allow for easy transportation, REBEL series can be rolled up, with the image out, with a minimum diameter of 6 inches (15cm). When the image is not protected by an overlaminate, make sure the print is completely dry and protected in a plastic bag. During transportation or storage, avoid exposing them to extreme temperature and humidity changes.
5. Applications: This film is recommended for use in flat to moderately curved surfaces on:
   a. Vending or dispensing machines and cooler graphics
   b. Indoor and outdoor graphics and signs
   c. Small format OEM decorative and identification graphics
6. This is film is not recommended for use on:
   a. Corrugated or complex surfaces
   b. Over rivets
   c. On flexible substrates (banners, canvas, etc.)
   d. Painted surfaces that are not thoroughly cured or properly bonded to the substrate.

1) The user is responsible for determining the product’s suitability, including adhesion and if needed, removal characteristics when used in applications other than listed specifically in this Performance Guide.
2)If there are any questions about applications, please contact your MACtac sales representative to discuss your requirements for recommendations.
3)If this is a printed Performance Guide it is an uncontrolled document. Please check the MACtac website for the latest, most up-to-date version.